XQ-1（2B） 金相式样镶嵌机 Metallographic Specimen Mounting Press 用途 XQ-2B型金相试样镶嵌机（以下简称镶嵌机）适用于对不是整形、不易手拿的微笑金相式样进行热固性塑料压制。成形后可方便地进行试样磨抛操作，也有利于在金相显微镜下进行县委组织测定。 镶嵌机在下列条件下能地工作。 1. 海拔高度不超过1000米； 2. 周围介质温度不高于 40℃，及不低于-10℃； 3. 空气在相对湿度不大于85%（在20℃时）； 4. 周围没有导电尘埃，爆炸性气体，及能严重破坏金属和绝缘的腐蚀性气体； 5. 没有明显的震动和颠簸。 Applications Model XQ-2B Metallographic Specimen Mounting Press(mounting press for shortp) is applicable for the most plastics pressing forming of tiny fractonal metallographic specimen. After formed, the specimen can be grinded and polished easily and its microstructure can be measured readily under metalloscope. The reliability of the mounting press can be assured under following conditions: 1. Altitude above the sea level less than 1000m. 2. Ambient temperature between 40 and -10. 3. Air relative humidity less than 85%(at 20 ). 4. No conductive dust, explosive gas and corrosive gas harmful to metal and insulation are insulation are around the machine. 5. No apparent Vibration and shaking. 结构特征概述 本机系机械式镶嵌机，旋转机休外手轮，通过一对锥齿轮带动机体内丝杆使压制试样的下模在钢模套内上下移动，热固性塑料连同镶嵌的试样在加热的条件下成形。试样制备过程中的成形压力由成形压力在机体内的弹簧自动补偿，试样压制的压力可由信号灯给以指示。 本机配有智能型数字显示温控器，能自动控温，设定温度与实测温度均有显示，温度传感器采用热电偶。本机具有高灵敏度、高精度，有温度显示，易观察又易操作等优点。每件试样镶嵌（用电玉粉）约12分钟。 Brief Description The mounting press is a mechanical type machine. By turning the hand-wheel outside the machine, a couple of bevel gear is rotated to drive the screw rod which in turn pushes/pulls the lower dieup and down along the mould sleeve, the thermosat plastics together with specimen being mounted is formed under heated conditions. During this process the pressure is self adjusted by a spring fixed inside the machine. A signal light is used to indicate the pressure level. 技术参数 1.试样压制规格 Specimen pressing size Φ22x15mm Φ30x15mm Φ45x15mm 2.加热器规格 Heater capacity 650w,220v 800w,220v 3.温度调节范围 Adjustable temperature range 0~160℃ 4.控制电源 Power 电压波动不大于±15 0v.50hz, voltage fluctuation less than ±15% 5.外形尺寸 Overall dimensions 340x280x400mm 6.净重 Net Weight 32kg